Disclaimer
Use BendMath as an estimating and reference aid only
BendMath calculators, charts, tables, and lookup tools are provided for screening, planning, and shop reference. They are not engineering certification, safety approval, installation instruction, or a substitute for qualified professional judgment.
Limits
Verify before production or maintenance work
- Sheet metal values depend on material lot, temper, grain direction, tooling, springback, and process.
- Press brake values depend on machine capacity, tooling ratings, bend length, V-die selection, and setup.
- Hydraulic fitting identification depends on measured diameter, pitch, taper, seat, seal, series, and supplier specifications.
- Grease compatibility depends on thickener, base oil, additives, temperature, seals, and manufacturer guidance.
- NEMA and AWG references are configuration facts only and are not wiring, installation, code, or safety advice.
Codes and standards
Applicable requirements take priority
Always verify with material suppliers, tooling suppliers, equipment manufacturers, lubricant manufacturers, applicable standards, the NEC where relevant, local jurisdiction requirements, and qualified professionals before using a value in the field or in production.
To report a correction or source concern, email [email protected].